Cover, Engine: Removal
WARNING: This page is about a different car, the 2018 RAM 2500 HD and 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the IAT sensor electrical connector (3).
- Remove the clean air tube (2) from the air cleaner housing (4) and the throttle body.
- Lift up the front of the engine cover (1) and separate the engine cover front grommets (2) from the ball studs on the intake manifold.
- Slightly raise the front of the engine cover and slide forward to remove the rear engine cover pegs (2) from the grommets (1) on the rear of the intake manifold.
- Remove the engine cover (1). Refer to COVER, ENGINE, REMOVAL .