LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1583 (Charging (Service Information) - 2500 Hd) >> Generator >> Removal >> 6.4L - Dual

6.4L - Dual

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disconnect the negative cable from the battery before removing the battery output wire (B+ wire) from the generator. Failure to do so can result in injury or damage to the electrical system.

GC0161593Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the secondary accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
    GC0161607Courtesy of CHRYSLER GROUP, LLC
  3. If required, Remove the secondary generator wiring harness (3) from the intake manifold.
  4. Partially raise the vehicle.
  5. Remove the right front wheel.
  6. Remove the inner splash shield.
    GC0161613Courtesy of CHRYSLER GROUP, LLC
  7. Unsnap the plastic insulator cap (4) from the B+ output terminal (2).
  8. Remove the B+ terminal mounting nut (3) at the rear of the generator. Disconnect the terminal from the generator.
  9. Disconnect the field wire connector (1) at the rear of the generator by pushing on the connector tab.
    GC0161535Courtesy of CHRYSLER GROUP, LLC
  10. Remove the front mounting bolts (2).
  11. Remove the side mount bolt (4).
    GC0161527Courtesy of CHRYSLER GROUP, LLC
  12. Using care, remove the generator (1) past the heater hose (2).
  13. Remove the generator (3) from vehicle.
scientia non olet · About LEMON Manuals