6.7L Diesel

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

Install the generator (1). Tighten bolts (2) to 48 N.m (35 ft. lbs.).

Courtesy of CHRYSLER GROUP, LLC
Install B+ terminal eyelet to generator output stud. Tighten nut to 15 N.m (133 in. lbs.).
Snap the plastic insulator cap (1) onto B+ output terminal.

Courtesy of CHRYSLER GROUP, LLC

CAUTION:
Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.

CAUTION:
When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to ACCESSORY DRIVE .
Connect the field wire connector (1) into the generator.
Install the serpentine drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
Install both negative battery cables.