Section 1583 (Charging (Service Information) - 2500 Hd): Generator: Installation: 6.4L

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

Position the generator (1) to the engine.
Install the mounting bolts (3). Torque the bolts to 50 N.m (37 ft. lbs.).

Courtesy of CHRYSLER GROUP, LLC
Snap the field wire connector (6) into the rear of the generator.
Install the B+ terminal eyelet (1) to the generator output stud.
Tighten the mounting nut (2) to 12 N.m (106 in. lbs.).

CAUTION:
Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.

CAUTION:
When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to ACCESSORY DRIVE .
Install the serpentine belt. Refer to BELT, SERPENTINE, INSTALLATION .
Install the negative battery cable.