LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1582 (Heating & Air Conditioning - (Service Information) - 2500 Hd) >> Plumbing >> Line, A/C Suction >> Removal >> 6.7L Diesel Engine

6.7L Diesel Engine

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.

GC0089599Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Remove the air filter housing.
  4. Remove the nut (1) that secures the A/C liquid line (2) and A/C suction line (3) to the A/C expansion valve (4).
  5. Disconnect the A/C liquid and suction lines from the A/C expansion valve and remove and discard the O-ring seals.
  6. Separate the A/C liquid line from the A/C suction line and install plugs in, or tape over the opened refrigerant line fittings and expansion valve ports.
    GC0137128Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Illustration shown with lower radiator hose removed for clarity.

  7. Remove the turbocharger outlet tube.
  8. Remove the nut (1) that secures the A/C suction line (3) to the A/C compressor (2).
  9. Disconnect the A/C suction line from the A/C compressor and remove and discard the O-ring seals and gaskets.
  10. Install plugs in, or tape over the opened suction line fittings and compressor port.
scientia non olet · About LEMON Manuals