LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1582 (Heating & Air Conditioning - (Service Information) - 2500 Hd) >> Plumbing >> Core, Heater >> Removal

Core, Heater: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE:

Disassembly of the HVAC housing is not required to remove heater core.

GC0089592Courtesy of CHRYSLER GROUP, LLC
  1. Remove the HVAC housing (4) and place it on a workbench. Refer to HOUSING, HVAC, REMOVAL .
  2. Remove the foam seal (1) from the flange (2).
  3. Remove the two screws (3) that secure the flange to the front of the HVAC housing.
  4. Carefully disengage the retaining tab that secures the flange to the HVAC housing and remove the flange.
    GC0089593Courtesy of CHRYSLER GROUP, LLC
  5. Carefully pull the heater core (2) out of the front of the HVAC housing (1).
  6. Inspect all foam seals and replace as required.
scientia non olet · About LEMON Manuals