Sensor, Oxygen: Installation: 6.4L
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Rear O2 sensors shown. Fronts similar.
Threads of new oxygen sensors are factory coated with anti-seize compound to aid in removal.DO NOT add any additional anti-seize compound to threads of a new oxygen sensor.
- Install the O2 sensor (3, 5). Tighten to 50 N.m (37 ft. lbs.)
- Connect the O2 sensor (1, 2) electrical connector.
- Lower vehicle.