Sensor, Air Temperature, Intake: Removal: 6.4L
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
 Courtesy of CHRYSLER GROUP, LLC
|
The intake manifold air temperature (IAT) sensor (1) is installed into the air intake hose.
- Disconnect electrical connector (2) from IAT sensor.
- Clean dirt from intake manifold at sensor base.
 Courtesy of CHRYSLER GROUP, LLC
|
| 1 - IAT SENSOR |
| 2 - SENSOR O-RING |
| 3 - RELEASE TAB |
- Gently lift on small plastic release tab (3) and rotate sensor about 1/4 turn counterclockwise for removal.
- Check condition of sensor O-ring.