Sensor, Temperature, Intake Manifold: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate both of the negative battery cables.
 Courtesy of CHRYSLER GROUP, LLC
|
- Remove the oil dipstick (2).
- Remove the bolts (1) and the engine cover (3).
 Courtesy of CHRYSLER GROUP, LLC
|
- Disconnect the intake manifold temperature sensor wire harness connector (2).
- Remove the intake manifold temperature sensor (3).