LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1580 (Fuel System - 2500 Hd) >> Fuel Injection, 6.7L Diesel >> Sensor, Inlet Air Temperature/Pressure >> Removal

Sensor, Inlet Air Temperature/Pressure: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate both of the negative battery cables.
    GC0108848Courtesy of CHRYSLER GROUP, LLC
  2. Disconnect the inlet air temperature/pressure sensor wire harness connector (6).
  3. Remove the screw (1) and the inlet air temperature/pressure sensor (2) from air cleaner cover.
  4. Check condition of sensor O-ring.
scientia non olet · About LEMON Manuals