LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1580 (Fuel System - 2500 Hd) >> Fuel Injection, 6.7L Diesel >> Sensor, Inlet Air Temperature/Pressure >> Installation

Sensor, Inlet Air Temperature/Pressure: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0108848Courtesy of CHRYSLER GROUP, LLC
  1. Check condition of sensor O-ring.
  2. Install the inlet air temperature/pressure sensor (2) into top of air cleaner cover and tighten the screw (1) to 1 N.m (9 in. lbs.).
  3. Connect the inlet air temperature/pressure sensor wire harness connector (6).
  4. Connect both negative battery cables.
scientia non olet · About LEMON Manuals