Sensor, Accelerator Pedal Position: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not attempt to separate or remove the Accelerator Pedal Position Sensor (APPS) from the accelerator pedal assembly. The APPS and the accelerator pedal is replaced as an assembly. If the sensor is removed from the pedal, the electronic calibration may be destroyed.
- Disconnect and isolate both the negative battery cables.
- Disconnect the Accelerator Pedal Position Sensor (APPS) wire harness connector (2).
- Remove the APPS lower mounting bolt (4) and two mounting nuts.
- Remove the pedal and APPS assembly (3) from vehicle.