Tube, Fuel Tank Filler: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Using a flat blade screwdriver, remove the cap less fuel filler locking tab cover (1) by prying the cover upwards and away from the support plate.
- Remove the support plate (2).NOTE:
Image shown without the filler tube, to show the tab locations.
- Insert two pocket screw drivers (2) in the side guide slots.
- Push down on the locking tabs (1) enough to clear the upper lockout housing.
- Twist the outer Lockout housing (1) counter clockwise and remove from the filler tube (3).
- Raise the vehicle.
- Remove the ground wire (5).
- Remove the filler neck (3) to filler support bracket bolt (4).
- Loosen the fuel filler tube hose clamp (2) at the fuel tank hose (3).
- Disconnect the fuel breather tube (6) from the fuel tank pressure sensor (4).
- Remove the filler tube from the vehicle.