Tube, Fuel Tank Filler: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Position the filler tube (1) to the fuel tank filler hose (3).
- Hand tighten the hose clamp (2).
- Install the fuel breather tube (6) to the tank pressure sensor (4).
- Install the filler tube (3) to filler tube bracket bolt (4). Tighten the to 12 N.m (106 in. lbs.).
- Install the screw (5) for the ground strap. Tighten the to 5 N.m (44 in. lbs.).
- Lower the vehicle.
- Position the filler tube through the filler tube housing rubber grommet (3).
- Install the cap-less housing (1) into the filler tube (2).
- Twist the cap-less housing clockwise to lock into position.
- Install the support plate (2) onto the lockout housing (1).
- Snap the locking tab cover onto the housing.