LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1580 (Fuel System - 2500 Hd) >> Fuel Delivery, 6.7L Diesel >> Tank, Fuel >> Installation

Tank, Fuel: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0108827Courtesy of CHRYSLER GROUP, LLC
  1. If removed, install the fuel pump module. Refer to MODULE, FUEL PUMP, INSTALLATION .
  2. Position the fuel tank assembly onto a transmission jack.
  3. Raise fuel tank assembly up to frame.
  4. Install fuel tank straps (4). Tighten the nuts (5) to 61 N.m (45 ft. lbs.).
  5. Remove the transmission jack.
    GC0108828Courtesy of CHRYSLER GROUP, LLC
  6. Connect the fuel return and supply line quick-connect fittings (4 and 5).
    GC0108830Courtesy of CHRYSLER GROUP, LLC
  7. Connect the fuel sending unit wire harness connector (1).
    GC0161625Courtesy of CHRYSLER GROUP, LLC
  8. Connect the fuel vapor hose (2) to tank fitting (1).
    GC0108829Courtesy of CHRYSLER GROUP, LLC
  9. Install the vent hoses (4) to tank fitting and securely tighten clamp (3).
  10. Install the filler hoses (6) to tank fitting and securely tighten clamp.
  11. Remove support and lower the vehicle.
  12. Connect both of the negative battery cables.
  13. Fill tank and check for leaks.
scientia non olet · About LEMON Manuals