6.7L Diesel
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the O-ring seal (2) with clean engine oil.
- Install the Camshaft Position (CMP) sensor (2) and tighten the bolt (1) to 12 N.m (9 ft. lbs.).
- Connect the CMP sensor wire harness connector (1).
- Install the left front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
- Connect both of the negative battery cables.