6.7L Diesel
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Install the starter motor. Tighten the three bolts (4) to 43 N.m (32 ft. lbs.).
- Connect solenoid wire harness connector (3).
- Install the B+ cable (1) onto stud. Tighten nut (2) to 24 N.m (18 ft. lbs.).
- Install the B+ cable (1) dust cover.
- If equipped, install the engine block stiffener (1). Tighten bolts (2) to 89 N.m (66 ft. lbs.).
- Lower the vehicle.
- Connect both negative battery cables.