LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1577 (6.4L Engine - (Service Information) - 2500 Hd) >> Lubrication >> Cooler And Lines, Oil >> Installation

Cooler And Lines, Oil: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Inspect seal conditions. Seals can be re-used, if not damaged. Position seal in the seal channel and press lightly into place. Repeat procedure for each seal position.

GC0161606Courtesy of CHRYSLER GROUP, LLC
  1. Lubricate seal and position oil filter adapter to the engine block. Tighten the bolts (2) to 12 N.m (9 ft. lbs.).
  2. If removed, install the oil filter connector (1). Tighten the bolts to 25 N.m (18 ft. lbs.).
    GC0161560Courtesy of CHRYSLER GROUP, LLC
  3. Install oil cooler (1). Tighten the bolts (2) to 12 N.m (9 ft. lbs.).
    GC0161575Courtesy of CHRYSLER GROUP, LLC
  4. Install the oil temperature sensor (1). Tighten the bolts (2) to 27 N.m (9 ft. lbs.).
  5. Connect the oil temperature sensor electrical connector (1).
  6. Connect oil cooler coolant hoses (4, 6).
  7. Install oil filter.
  8. Install the oil filter funnel.
  9. If removed, install the secondary generator. Refer to GENERATOR, INSTALLATION .
  10. Lower vehicle.
  11. Fill cooling system. Refer to STANDARD PROCEDURE .
  12. Connect the battery negative cable.
scientia non olet · About LEMON Manuals