LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1577 (6.4L Engine - (Service Information) - 2500 Hd) >> Engine Mounting >> Insulator, Engine Mount, Rear (Transmission) >> Installation

Insulator, Engine Mount, Rear (Transmission): Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0154452Courtesy of CHRYSLER GROUP, LLC
NOTE:

4wd mount shown. 2wd mount similar.

NOTE:

Threadlocking compound must be applied to the bolts before installation.

  1. If removed, position the heat shields (4) onto the insulator (5).
  2. Position the insulator to the upper transmission mount bracket (2). Tighten the nuts (1) to 61 N.M (45 ft. lbs.).
  3. Align the transmission mount to the transmission.
  4. Install the bolts (3) that attach the transmission bracket to the transmission. Tighten the bolts to 64 N.M (47 ft. lbs.).
  5. Lower the transmission so the transmission mount rest on the crossmember and the studs of the transmission mount are aligned in the slots in the crossmember.
  6. Install the nuts (6) onto the transmission mount studs through the crossmember access slot.
  7. Tighten the nuts to 61 N.M (45 ft. lbs.).
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals