LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1577 (6.4L Engine - (Service Information) - 2500 Hd) >> Engine Block >> Damper, Vibration >> Installation

Damper, Vibration: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

To prevent severe damage to the crankshaft, damper, and damper installer, thoroughly clean the damper bore and the crankshaft nose before installing damper.

  1. Position the damper onto crankshaft.
  2. Assemble the damper installer (special tool #10387, Installer, Vibration Damper) (2), and the pressing cup (1) from A/C hub installer (special tool #6871, Installer, A/C Hub).
  3. Using the damper installer (special tool #10387, Installer, Vibration Damper) (2), and the pressing cup (1) from the A/C hub installer (special tool #6871, Installer, A/C Hub), press the damper onto crankshaft.
    GC0143968Courtesy of CHRYSLER GROUP, LLC
  4. Install the crankshaft damper bolt.
  5. Position the (special tool #10386, Holder, Vibration Damper) (2), onto the vibration damper (3).
  6. Tighten the bolt to 185 N.m (136 ft. lbs.).
  7. Install the lower fan shroud.
  8. Lower the vehicle.
    GC0088055Courtesy of CHRYSLER GROUP, LLC
  9. Install the accessory drive belt (1). Refer to BELT, SERPENTINE, INSTALLATION .
  10. If removed, install the secondary generator belt.
  11. Connect the negative cable to battery.
scientia non olet · About LEMON Manuals