LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1577 (6.4L Engine - (Service Information) - 2500 Hd) >> Cylinder Head >> Cover(S), Cylinder Head >> Removal >> Left

Cover(S), Cylinder Head: Removal: Left

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0155269Courtesy of CHRYSLER GROUP, LLC
  1. Remove the nut (1) and the negative battery cables (10, 11).
  2. Remove the engine cover.
    GC0089586Courtesy of CHRYSLER GROUP, LLC
  3. Remove the oil indicator bolt.
  4. Remove the accessory drive belt.
  5. Disconnect the A/C compressor harness connector.
  6. Remove the A/C compressor (3) from the engine block.
    GC0158097Courtesy of CHRYSLER GROUP, LLC
  7. Separate the A/C line support bracket (2).
  8. Position the A/C compressor aside.
    GC0158183Courtesy of CHRYSLER GROUP, LLC
  9. Disconnect the ignition coil harness connectors (2).
  10. Disconnect the fuel injector harness connectors (1).
  11. Position the engine harness aside.
    GC0080076Courtesy of CHRYSLER GROUP, LLC
  12. Remove the ignition coil retaining bolts.
  13. Remove the ignition coils (1).
    GC0080292Courtesy of CHRYSLER GROUP, LLC
  14. Using the sequence shown, remove the cylinder head cover retaining bolts.
    GC0139403Courtesy of CHRYSLER GROUP, LLC
  15. Remove the cylinder head cover (1).
  16. Clean the sealing surface of the cylinder head (2).
NOTE:

The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.

scientia non olet · About LEMON Manuals