Camshaft Bearings/Bores
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Camshaft bores No. 2-6 do not use a bearing.
- Inspect the camshaft bearing and bores for signs of excessive wear.
- Measure the camshaft bearing and bores with a telescoping bore gauge and micrometer. If out of specification, refer to REMOVAL .
- Inspect the front camshaft bearing (1) oil holes for alignment with cylinder block.
- Inspect the rear camshaft bearing (2) oil holes for alignment with cylinder block.