LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (6.7L Engine (Service Information) - 2500 Hd) >> Cylinder Head >> Rocker Arm, Valve >> Installation

Rocker Arm, Valve: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0169614Courtesy of CHRYSLER GROUP, LLC
  1. Install the push rod(s) (1) in their original location. Verify that they are seated in the tappets. 
    GC0169609Courtesy of CHRYSLER GROUP, LLC
  2. Lubricate the valve tips and install the crossheads (4) in their original locations.
  3. Lubricate the top crossheads (4) and push rod sockets and install the rocker arms (2) and pedestals (3) in their original locations. Tighten bolts (1) to 36 N.m (27 ft. lbs.).
  4. Verify valve lash adjustment. Refer to  STANDARD PROCEDURE   . 
  5. Install the cylinder head cover. Refer to COVER(S), CYLINDER HEAD, INSTALLATION, 6.7L .
  6. Connect both of the negative battery cables.
scientia non olet · About LEMON Manuals