Cylinder Head Cover
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Gasket must be completely dry and free of oil before installation. Pneumatic tools should NOT be used to remove or install the cover.
- Clean all the gasket sealing surfaces. Refer to ENGINE GASKET SURFACE PREPARATION .
- Inspect the cylinder head cover gasket (2) for tears, or splits. Replace if necessary.
- If removed, install the cylinder head cover gasket (2) on the rocker box. Tighten the fuel injector wire harness nuts (1) to 1.50 N.m (13 in. lbs.).
- If removed, connect both of the fuel injector wire harness connectors (1).NOTE:
Pneumatic tools should NOT be used to remove or install the cover.
- Install the cylinder head cover (2). Tighten the bolts (1) from the center out to 24 N.m (18 ft. lbs.).
- Install the Closed Crankcase Ventilation (CCV) drain tubes (3) to the cylinder head cover.
- Install the crankcase breather and CCV cover. Refer to SYSTEM, CLOSED CRANKCASE VENTILATION (CCV), INSTALLATION
.
- Connect the crankcase pressure sensor 2 wire harness connector (1).
- Connect the crankcase pressure sensor 1 wire harness connector (7).
- Install the engine cover (3). Tighten the bolts (1) to 10 N.m (89 in. lbs.).
- Install the engine oil dipstick (2).
- Connect both of the negative battery cables.
- Start the vehicle and check for leaks.