LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1576 (6.7L Engine (Service Information) - 2500 Hd) >> Air Intake System >> Body, Air Cleaner >> Installation

Body, Air Cleaner: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0179946Courtesy of CHRYSLER GROUP, LLC
  1. Attach the wire harness retainer (2) and connect the ram air actuator wire harness connector (1), then position the air cleaner body in place.
    GC0179978Courtesy of CHRYSLER GROUP, LLC
  2. Install the air cleaner body (1) and push down to lock in place.
  3. Install the intake air tube (3) onto the air cleaner body (1) and tighten the clamp (4) 4 N.m (35 in. lbs.).
  4. Attach the wire harness (5) to the intake air tube (3).
  5. Connect the TBAP sensor wire harness connector (6).
  6. Connect the Mass Air Flow (MAF) sensor wire harness connector (4).
    GC0155101Courtesy of CHRYSLER GROUP, LLC
  7. Install the air cleaner body bolt (2) and tighten to 8 N.m (71 in. lbs.).
  8. Connect both of the negative battery cables.
scientia non olet · About LEMON Manuals