LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1575 (6.7L Diesel - DTCS P24A2 To U3017 - 2500 Hd) >> DTC Troubleshooting >> U3017-Control Module Timer/Clock Performance >> Set Condition

Set Condition

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

The BCM engine ignition off time is too high or low for the coolant temperature drop observed over the key cycle. The PCM will light the MIL lamp after this monitor runs and fails twice. The PCM will turn off the MIL lamp once the diagnostic runs and passes in four consecutive drive cycles. Note: This DTC can also set when using the scan tool to change the vehicle from Shipping Mode to Customer Mode (during New Vehicle Prep).

scientia non olet · About LEMON Manuals