LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1573 (6.7L Diesel - DTCS P065A To P209F - 2500 Hd) >> DTC Troubleshooting >> P202B-REDUCTANT Tank Heater Control Circuit Low >> Possible Causes

Possible Causes

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Possible Causes
DIESEL EXHAUST FLUID TANK HEATER SUPPLY CIRCUIT SHORTED TO GROUND
DIESEL EXHAUST FLUID TANK HEATER SUPPLY CIRCUIT OPEN/HIGH RESISTANCE
DIESEL EXHAUST FLUID TANK HEATER GROUND CIRCUIT OPEN/HIGH RESISTANCE
DIESEL EXHAUST FLUID SUPPLY PUMP ASSEMBLY
DIESEL EXHAUST FLUID DOSING CONTROL UNIT

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Refer to  PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE  . 

NOTE:

One of the DEF Line Heater monitors runs only when the DEF Line Heater Relay is commanded on. If the ambient temperature is too warm for the DEF Line Heaters to be turned on, the DTC may remain active and may not be able to be erased after repair is completed. Using the scan tool, navigate to Actuator Tests and actuate the DEF Reductant Pressure Line Heater test for the appropriate Line Heater to run the diagnostic and determine if the repair has been completed. If the repair is complete, the fault will move to stored and be able to be cleared with the scan tool.