Diagnostic Test

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DTC
1. Ignition on, engine not running.
2. With the scan tool, clear the DTC.
3. Start or crank the engine.
4. With the scan tool, read DTCs.
  Did the DTC reset?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to POWERTRAIN VERIFICATION TEST .
CRANK AND CAM SENSOR CONNECTORS REVERSED
1. This DTC indicates that the CKP and CMP Position Sensor signals are reversed.
2. Switch the CKP and CMP Position Sensor connectors.
3. With the scan tool, clear the DTC.
4. Start or crank the engine.
5. With the scan tool, read DTCs.
  Did the DTC reset?
  
  Yes
  - Using the wiring diagram as a guide, check the connectors and wiring for proper configuration.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Repair complete.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .