LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1569 (Engine Cooling System - 2500 Hd) >> Engine >> Sensor, Coolant Temperature >> Removal >> 6.4L

Sensor, Coolant Temperature: Removal: 6.4L

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The temperature sensor is located on the front side of the water pump.

  1. Partially drain the cooling system. Refer to STANDARD PROCEDURE .
    WARNING:

    Hot, pressurized coolant can cause injury by scalding. Cooling system must be partially drained before removing the engine coolant temperature (ECT) sensor.

  2. Disconnect the electrical connector from the engine coolant temperature (ECT) sensor.
  3. Remove the ECT sensor from the water pump assembly.
scientia non olet · About LEMON Manuals