LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1569 (Engine Cooling System - 2500 Hd) >> Engine >> Pump, Water >> Removal >> 6.4L

Pump, Water: Removal: 6.4L

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Intake Manifold Removal/Installation Sequence
GC0161638Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect negative battery cable.
  2. Remove the intake assembly. Refer to REMOVAL .
    GC0161633Courtesy of CHRYSLER GROUP, LLC
  3. Remove the mechanical cooling fan assembly. Refer to FAN, COOLING, VISCOUS, REMOVAL .
  4. Drain coolant into a clean container. Refer to STANDARD PROCEDURE .
  5. Remove the upper radiator hose (4) from the thermostat housing (1) and position aside.
  6. If equipped, remove the secondary generator. Refer to GENERATOR, REMOVAL .
  7. Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
    GC0158447Courtesy of CHRYSLER GROUP, LLC
  8. Separate the hose (3) from the lower bypass tube.
  9. Remove lower radiator hose (2) from the water pump and position aside.
    GC0161551Courtesy of CHRYSLER GROUP, LLC
  10. Remove the EGR cooler hose (2) at the bypass tube (3).
  11. Remove the bolt (1) for the upper bypass tube from the timing cover.
    GC0161539Courtesy of CHRYSLER GROUP, LLC
  12. Remove the supply line (3).
  13. Disconnect the temperature sensor electrical connector (2).
  14. Remove the supply line bracket nut (1).
    Fig 2: Water Pump Removal & Installation Sequence
    GC0161597Courtesy of CHRYSLER GROUP, LLC
  15. Remove belt tensioner assembly (1) to gain access to the water pump bolt (14). Refer to TENSIONER, BELT, REMOVAL .
  16. Remove water pump mounting bolts and remove pump from the timing cover.
scientia non olet · About LEMON Manuals