LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1569 (Engine Cooling System - 2500 Hd) >> Engine >> Pump, Water >> Installation >> 6.4L

Pump, Water: Installation: 6.4L

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Water Pump Removal & Installation Sequence
GC0161597Courtesy of CHRYSLER GROUP, LLC
  1. Clean mating surfaces and install water pump. Tighten mounting bolts in sequence to Specifications. Refer to TECHNICAL SPECIFICATIONS .
  2. Install belt tensioner assembly (14). Refer to TENSIONER, BELT, INSTALLATION .
    GC0158447Courtesy of CHRYSLER GROUP, LLC
  3. Install the lower radiator hose (5).
  4. Install the lower bypass hose (3).
    GC0161539Courtesy of CHRYSLER GROUP, LLC
  5. Install the supply line bracket (1).
  6. Connect the temperature sensor electrical connector (2).
  7. Install the supply line (3).
    GC0161551Courtesy of CHRYSLER GROUP, LLC
  8. Install upper bypass tube (3).
  9. Install the EGR cooler hose (2).
    GC0161633Courtesy of CHRYSLER GROUP, LLC
  10. Install the upper radiator hose (4) to the thermostat housing (1).
  11. Install cooling fan assembly. Refer to FAN, COOLING, VISCOUS, INSTALLATION .
  12. Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
  13. If removed, install the secondary generator. Refer to GENERATOR, INSTALLATION .
    Fig 2: Intake Manifold Removal/Installation Sequence
    GC0161638Courtesy of CHRYSLER GROUP, LLC
  14. Install the Intake manifold. Refer to INSTALLATION .
  15. Connect negative battery cable.
  16. Check cooling system for leaks. Refer to DIAGNOSIS AND TESTING .
scientia non olet · About LEMON Manuals