Heater, Engine Block: Installation: 5.7L
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - BLOCK HEATER |
- Thoroughly clean cylinder block core hole and block heater seat.
- Insert block heater assembly (1) into the block.
- With block heater fully seated, tighten bolt (2) to 2 N.m (17 in. lbs.) torque.
- Connect the power cord (3) to the block heater.
- Install the starter. Refer to STARTER, INSTALLATION .