LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1569 (Engine Cooling System - 2500 Hd) >> Engine >> Fan, Cooling, Viscous >> Removal >> 6.7L Diesel

6.7L Diesel

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

If the electronically controlled viscous fan drive is replaced because of mechanical damage, the cooling fan blades should also be inspected. Inspect for fatigue cracks, or chipped blades that could have resulted from excessive vibration. Replace fan blade assembly if any of these conditions are found. Also inspect wiring harness and connectors for damage.

GC0161582Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate both negative battery cables.
  2. Remove the engine oil dip stick (2).
  3. Remove bolts (1) and the engine cover (3).
    GC0155180Courtesy of CHRYSLER GROUP, LLC
  4. Remove fasteners (2) and the upper radiator shroud (1).
    GC0155266Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the electronically controlled viscous fan wire harness connector (2).
  6. Remove push pin retainer (1) securing the fan drive wire harness from support bracket.
    GC0155312Courtesy of CHRYSLER GROUP, LLC
  7. Remove the driver side fan shroud- mounting nut (1).
    GC0155096Courtesy of CHRYSLER GROUP, LLC
  8. Remove the passenger side fan shroud mounting nut (1) located on the of the vehicle.
    GC0155228Courtesy of CHRYSLER GROUP, LLC
  9. Remove the two bottom fan shroud nuts (1).
    CAUTION:

    Do not remove the fan pulley bolts. This pulley is under spring tension.

  10. The electronically controlled viscous fan drive/fan blade assembly is attached (threaded) to the fan pulley shaft. Remove the fan blade/fan drive assembly from fan pulley by turning the mounting nut counterclockwise (as viewed from front). Threads on the viscous fan drive are RIGHT-HAND.  A 48 MM Fan Wrench can be used. Place a bar or screwdriver between the fan pulley bolts to prevent pulley from rotating.
  11. Collapse fan shroud toward front of vehicle and remove fan drive/fan blade and fan shroud as an assembly.
    GC0155302Courtesy of CHRYSLER GROUP, LLC
  12. Disconnect the wire harness connector (2) and remove bracket (1) from the fan hub (3).
    GC0155327Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    The electronically controlled viscous fan drive is vibration and impact sensitive, especially at the electrical connectors. Do not drop the unit.

  13. Remove the four fan blade mounting nuts (2) from the viscous fan drive (1).
  14. Inspect the fan for cracked, chipped or damaged fan blades (1).
  15. If necessary, remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
    GC0155183Courtesy of CHRYSLER GROUP, LLC
  16. If necessary, remove bolts (2) and the fan drive pulley (1).
    GC0155277Courtesy of CHRYSLER GROUP, LLC
  17. If necessary, remove bolts (1) and the fan drive hub (2).
  18. Disengage the fan shroud lower retaining clips.
scientia non olet · About LEMON Manuals