LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1569 (Engine Cooling System - 2500 Hd) >> Engine >> Fan, Cooling, Electric >> Removal

Fan, Cooling, Electric: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0087421Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the upper radiator seal push pins (1).
  3. Remove the upper radiator seal plastic rivets (2).
  4. Remove the upper radiator seal.
  5. If equipped, remove the viscous fan assembly from the water pump hub shaft. Refer to FAN, COOLING, VISCOUS, REMOVAL .
    GC0087422Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the radiator fan (3) electrical connector.
  7. Remove the fan shroud (1, 2) to radiator mounting bolts (4).
  8. Disengage the fan shroud's (1, 2) lower retaining clips and position the fan shroud (1, 2) towards the rear of vehicle.
  9. Disengage the electric cooling fan (3) to radiator upper retaining clips.
  10. Disengage the electric fan (3) to radiator lower retaining clips.
  11. Pulling upward remove the viscous fan, radiator fan shroud (1, 2) and the electric cooling fan (3) as an assembly.
  12. The lower fan shroud (1) can be removed from the upper fan shroud (2) if needed.
  13. If damaged, remove radiator fan resistor from shroud (1, 2).
scientia non olet · About LEMON Manuals