Stabilizer Link
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle.
- Hold the stabilizer link (3) shafts with a wrench and remove the link nuts at the stabilizer bar (1).
- Remove the retainers and grommets from the stabilizer bar links (3).
- Hold the stabilizer link (3) shafts with a wrench and remove the link nuts at the axle brackets (2).
- Remove the links (3) from the axle brackets with Puller (special tool #C-3894-A, Puller, Tie Rod).