LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1568 (Front Suspension & Wheel Alignment - 2500 Hd) >> Front, Link And Coil >> Arm, Control >> Removal

Arm, Control: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Paint or scribe alignment marks on the cam adjusters and control arm for installation reference.
    NOTE:

    Discard the nuts and bolts and do not reuse, New nuts and bolts should be used when replacing or servicing the control arms.

  3. Support the front axle by placing a jack stand under the side of the axle that is being worked on.
    GC0155463Courtesy of CHRYSLER GROUP, LLC
  4. Remove the lower shock fastener (4, 5) and position shock out of mounting bracket.
    GC0155410Courtesy of CHRYSLER GROUP, LLC
  5. Remove the lower control arm nut, cam and cam bolt from the axle and loosen the upper control arm nut and bolt (2).
    GC0155424Courtesy of CHRYSLER GROUP, LLC
  6. Remove the nut and bolt from the frame rail bracket (1).
  7. Remove the upper control arm nut and bolt and remove the control arm.
scientia non olet · About LEMON Manuals