LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1568 (Front Suspension & Wheel Alignment - 2500 Hd) >> Front, Link And Coil >> Arm, Control >> Installation

Arm, Control: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Discard the nuts and bolts and do not reuse. New nuts and bolts should be used when replacing or servicing the control arms.

GC0155424Courtesy of CHRYSLER GROUP, LLC
  1. Position the control arm (2) at the axle brackets and frame rail bracket (1).
  2. Install the rear bolt (1) and finger tighten the nut.
    GC0155410Courtesy of CHRYSLER GROUP, LLC
  3. Install the cam bolt (2), cam and nut in the axle and align the reference marks.
  4. Install the upper control arm bolt and nut.
    GC0155463Courtesy of CHRYSLER GROUP, LLC
  5. Position the lower shock (6) into the mounting bracket.
  6. Install the lower shock bolt and fastener (4, 5) and tighten to specifications. Refer to FRONT, LINK AND COIL, TECHNICAL SPECIFICATIONS .
  7. Remove jack stand from axle.
  8. Remove support and lower the vehicle.
    GC0155410Courtesy of CHRYSLER GROUP, LLC
  9. Tighten the upper bolt fastener to axle bracket to specifications. Refer to FRONT, LINK AND COIL, TECHNICAL SPECIFICATIONS .
  10. Tighten cam nut at the axle bracket to specifications. Refer to FRONT, LINK AND COIL, TECHNICAL SPECIFICATIONS .
    GC0155424Courtesy of CHRYSLER GROUP, LLC
  11. Tighten the rear nut at the frame bracket to specifications. Refer to FRONT, LINK AND COIL, TECHNICAL SPECIFICATIONS .
scientia non olet · About LEMON Manuals