LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1567 (Tires & Wheels - (Service Information) - 2500 Hd) >> Wheels >> Cover, Wheel >> Installation >> Rear

Cover, Wheel: Installation: Rear

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install one 1 1/2 inch valve stem extension on each rear inner wheel.
    NOTE:

    A 3/8 in. drive 10mm deep wheel socket with a 10 in. or greater extension can be used to remove the existing valve stem cap and install the extension.

  2. Install one 1 in. valve stem extension on each outer wheel.
  3. Align the cooling windows of the wheel skin with the cooling windows of the wheel. Seat one side of the wheel skin's retainer onto the wheel. Using a rubber mallet, strike thew wheel skin on the outer circumference. Strike at several locations around the circumference until the skin is fully seated.
    NOTE:

    The wheel skin and the hub cap are fully seated when there is a consistent gap between the skin/cap and the wheel.

  4. Tug on the hub/cap wheel skin to ensure that they are properly installed.
scientia non olet · About LEMON Manuals