LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1567 (Tires & Wheels - (Service Information) - 2500 Hd) >> Wheels >> Cover, Wheel >> Installation >> Front

Cover, Wheel: Installation: Front

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the valve stem with the notch in the wheel skin.
  2. Seat on side of the wheel skin's wire retainer on to the wheel.
  3. Using a rubber mallet, strike the opposite side of the wheel skin until the skin is properly seated.
    NOTE:

    The wheel skin and the hub cap are fully seated when there is a consistent gap between the skin/ cap and the wheel.

  4. Tug on the hub cap/wheel skin to ensure that they are properly installed.
scientia non olet · About LEMON Manuals