Control Unit, Winch: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Solenoid #4 shown in the illustration, all others similar.
- Install the control wires (2) to all the solenoids and install the nuts (1).
- Tighten the nuts to 3 N.m (25 in. lbs.).
- Install the red battery positive cable (1) and install the switch wire.
- Install the nut and tighten to 10 N.m (85 in. lbs.).
- Install the control unit cover (1) and install the three screws (2).
- Install the winch assembly (2). Refer to WINCH, INSTALLATION .
- Connect the battery negative cable (3) and verify winch operation.