Passenger Side
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding with the following repair procedure, review all warnings and cautions. Refer to SEATS, WARNING .
- Carefully release the front clip and separate the jack cover (2) from the front of the riser (1).
- Carefully pull the cover forward and release the rear hook from the rear of the riser (3).
- Disconnect the electrical connector (1), if equipped.
- Remove the front passenger seat bolts (3).
- Remove the center seat bolts (2), if equipped with the center seat.
- Remove the rear bolts (1) and remove the passenger seat assembly.
- Disconnect the rear air duct (1) by sliding the telescoping duct section, attached to the seat, rearward.