LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Body - Interior & Exterior - 2500 Hd) >> Seats >> Seat Back, Rear >> Assembly >> Notes

Seat Back, Rear: Assembly: Notes

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0084645Courtesy of CHRYSLER GROUP, LLC
  1. Position the cover (3) on to the foam (1) and install three new hog rings (2).
  2. Position the foam and cover assembly over the seat back frame.
    GC0089119Courtesy of CHRYSLER GROUP, LLC
  3. Secure the J-straps (1 and 5)
  4. Position the armrest into the seat cavity and secure the upper hooks (2).
  5. Seat the armrest fully into the seat cavity and install the screws (3) and nuts (4).
  6. Tighten the screws and nuts to 28 N.m (21 ft. lbs.)
    GC0089118Courtesy of CHRYSLER GROUP, LLC
  7. Secure the J-strap (1).
  8. Install two new rear hog rings (2).
    GC0089117Courtesy of CHRYSLER GROUP, LLC
  9. Secure the J-straps (2).
    GC0089114Courtesy of CHRYSLER GROUP, LLC
  10. Install the new head restraint sleeves with slave sleeve (4) in the right position and master sleeve (3) in the left position.
  11. Press the lock buttons (2) on the sleeves and insert the head restraint tubes (1) into the head restraint guide sleeves, ensuring proper forward facing orientation of the head restraint.
  12. Install the seat back. Refer to SEAT BACK, REAR, INSTALLATION .
scientia non olet · About LEMON Manuals