Seat Back, Front: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Install the seat back (1) onto the seat cushion assembly and install the four bolts (2).
- Tighten the bolts (2) to 40 N.m (30 ft. lbs.).
- On manual reclining seats, install the recliner rod (2) onto the recliner lever and fully seat the clip (1).
- Position the wire harness (1) through the suspension mat (2).
- Secure the suspension mat (2) to the cross brace.
- Install the outer side shield and seat the clips (2) fully.
- Install the screw (1).NOTE:
Power seat bezel shown in the illustration, manual seat bezel similar.
- Connect the wire harness connectors to the power seat switch and memory seat switch, if equipped.
- Position the bezel (1) back into place and secure the front tab (2).
- Seat the remaining tabs (3) fully.
- If equipped, connect the lumbar switch electrical connector (1).
- If equipped with manual seat, install the seat recline handle. Make sure the clip holding the handle is fully engaged.
- Install the inboard shield (2) and install the screw (1).
- Install the side shield screws (2).
- Secure the seat back cover straps (2).
- Connect the electrical connectors (1).
- Install the front seat. Refer to INSTALLATION .