Seat Back, Front: Assembly
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
While servicing seat assemblies, Refer to SEAT, MEGA CAB REAR, DESCRIPTION .
- Connect the upper support wires (1) to the seat back frame.
- Secure the lumbar mat side wires (3).
- Secure the vented seat motorclips (2) to the lumbar support, if equipped.
- Secure the lower lumbar mat (1) to the clips (2).
- If equipped, position the lumbar motor (2) onto the seat back frame and install the bolt (3).
- Tighten the bolt (3) to 10 N.m (89 in. lbs.).
- Connect the electrical connector (1).
- Position the vented seat bag (1) through the seat back support spring (3).
- Position the vented seat bag (1) onto the vent motor (2) and seat the clips fully.
- Seat the foam and cover assembly over the seat back frame fully and secure the J-straps (1 and 2).
- Install the new head restraint sleeves with slave sleeve (4) in the right position and master sleeve (3) in the left position.
- Press the lock buttons (2) on the sleeves and insert the head restraint tubes (1) into the head restraint guide sleeves, ensuring proper forward facing orientation of the head restraint.
- Install the brace (2) and install the screws (1).
- Position the inner shields (1) back and seat the locator pin (2) fully.
- Install the seat back. Refer to SEAT BACK, REAR, INSTALLATION .