Cover, Seat Cushion, Rear: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
It is not necessary to remove the rear seat assembly in order to remove the seat cushion foam and cover.
- Place the cushion into the up position.
- Disconnect the seat cushion heat mat electrical connector, if equipped.
- Release the J-straps (2) and remove the foam/cover (1) from the seat cushion frame.
- Roll the cover (3) off of the foam (1) and remove the hog rings (2).
- Separate the cover from the foam.
- Remove the seat cushion frame bolts and remove the seat cushion frame. Refer to SEAT, MEGA CAB REAR, DESCRIPTION .