LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Body - Interior & Exterior - 2500 Hd) >> Seats >> Cover, Seat Cushion, Rear >> Installation

Cover, Seat Cushion, Rear: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0084645Courtesy of CHRYSLER GROUP, LLC
NOTE:

It is not necessary to remove the rear seat assembly in order to remove the seat cushion foam and cover.

  1. Install the seat cushion frame and install the seat cushion frame bolts. Refer to SEAT, MEGA CAB REAR, DESCRIPTION .
  2. Tighten the seat cushion frame bolts to 55 N.m (41 ft. lbs.)
  3. Position the cover (3) on to the foam (1) and install three new hog rings (2).
  4. Position the foam and cover assembly over the seat cushion frame.
    GC0085491Courtesy of CHRYSLER GROUP, LLC
  5. Install the seat cushion foam/cover (1) over the seat cushion frame and secure the J-straps (2).
  6. Connect the seat cushion heat mat electrical connector, if equipped.
scientia non olet · About LEMON Manuals