LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Body - Interior & Exterior - 2500 Hd) >> Seats >> Cover, Seat Cushion, Mega Cab Rear >> Removal

Cover, Seat Cushion, Mega Cab Rear: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fold both rear seats flat.
  2. Remove the filler panels from the rear seat to storage compartment.
  3. Separate the J-straps at the bottom of the seat back.
  4. Remove both hinge covers from the back section being worked on.
  5. Remove the lower anchor for the center seat belt.
  6. Disconnect the lower cable attachment from the seat back release.
  7. Remove the four bolts and remove the seat back from the seat.
  8. Remove the screw and remove the seat back release bezel.
  9. Mark the location of the release cables at the cushion and remove.
  10. Remove the upper cushion pivot bolts.
  11. Remove the lower cushion pivot bolts.
  12. Remove the cushion from the seat.
  13. Remove the seat release lever from the cushion.
  14. Separate the J-straps securing the cover to the seat pan.
  15. Remove the foam and cover from the seat pan.
  16. Separate the foam from the cover.
scientia non olet · About LEMON Manuals