LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Body - Interior & Exterior - 2500 Hd) >> Seats >> Cover, Seat Cushion, Mega Cab Rear >> Installation

Cover, Seat Cushion, Mega Cab Rear: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat cushion foam into the cover.
  2. Position the cushion assembly onto the seat pan.
  3. Connect the J-straps securing the cover to the seat pan.
  4. Install the seat release lever.
  5. Install the cushion assembly onto the seat assembly.
  6. Install the lower cushion pivot bolts.
  7. Install the upper cushion pivot bolts.
  8. Install the release cables using the marks created during removal.
  9. Install the seat back release bezel and install the screw.
  10. Install the seat back and install the four bolts.
  11. Connect the lower cable attachment from the seat back release.
  12. Install the lower anchor fro the center seat belt.
  13. Install both hinge covers for the back section seat back.
  14. Connect the J-straps at the bottom of the seat back.
  15. Install the filler panels for the rear storage compartment.
scientia non olet · About LEMON Manuals