LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Body - Interior & Exterior - 2500 Hd) >> Seats >> Cover, Seat Cushion, Front >> Removal >> Manual

Cover, Seat Cushion, Front: Removal: Manual

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0089095Courtesy of CHRYSLER GROUP, LLC
  1. Separate the seat back cover straps (2) from under the seat cushion.
    GC0089096Courtesy of CHRYSLER GROUP, LLC
  2. Remove the side shield screws (2) in the back.
    GC0089097Courtesy of CHRYSLER GROUP, LLC
  3. Remove the inboard shield screw (1).
  4. Remove the inboard side shield (2).
    GC0089125Courtesy of CHRYSLER GROUP, LLC
  5. Using a door handle clip tool (1) or equivalent, release the clip holding the handle (2) onto the seat and remove the handle.
  6. Using trim stick (special tool #C-4755, Trim Stick) or equivalent, release the seven tabs and separate the center bezel from the outboard side shield.
  7. Pull the bezel rearward and release the front retaining tab.
    GC0089101Courtesy of CHRYSLER GROUP, LLC
  8. Remove the screw (1).
  9. Release the retaining clips (2) and remove the outer side shield.
    GC0089126Courtesy of CHRYSLER GROUP, LLC
  10. Separate the clip (1) and separate the recliner rod (2) from the lever.
  11. Remove the push pin fastener (3).
    GC0089127Courtesy of CHRYSLER GROUP, LLC
  12. Separate the cover J-straps (1) from the sides and remove the foam/cover assembly.
    GC0089128Courtesy of CHRYSLER GROUP, LLC
  13. Remove the 10 hog rings (2) and separate the cover (1) from the foam.
scientia non olet · About LEMON Manuals