LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1564 (Body - Interior & Exterior - 2500 Hd) >> Seats >> Cover, Seat Back, Mega Cab Rear >> Installation

Cover, Seat Back, Mega Cab Rear: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place cover over the foam and install onto the seat pan.
  2. Connect the J-straps to the pan.
  3. Install the release/recliner handle.
  4. Install the cushion assembly onto the seat assembly.
  5. Install the lower cushion pivot bolts.
  6. Install the upper cushion pivot bolts.
  7. Install the cables at the cushion using the marks made during removal.
  8. Install the seat back onto the seat and install the four bolts.
  9. Connect the lower cable attachment for the seat back release.
  10. Install the lower anchor for the center seat belt.
  11. Install the hinge covers.
  12. Connect the J-straps at the bottom of the seat back being worked on.
  13. Install the filler panels.
scientia non olet · About LEMON Manuals